This was something I did this morning, to help someone out.
If you look at most Small Section steel windows, the bolt or
nut, is very close to the glass and trying to get a normal spanner
behind the bracket, is in most cases. . . . . almost impossible!
When I was "on the spanners", as the term goes - the way around
this problem, was to convert a flat type Bicycle Spanner.
This is this enough, at just under 4mm, to fit where you need it to
and with a little modification - dressing down the end and forming
a crank in the handle, it works a treat.
I may do a small production run of spanners for metal windows, as
it is something we keep getting asked about.
It may prevent a lot of frustration - the person I made this one for
had been looking around for ages and had tried all sorts if things to
tighten his handle up.
Result!
If
you see anything on this blog, that you think would help you out or you
have any questions and would like to speak to someone - please give us a
call.
We have readers from all over the world but we are UK based, in the East Midlands.
0116 2742195.
No comments:
Post a Comment